Ultra Start KE-6 Przewodnik Instalacji Pobierz pdf (Strona 12)

Installation Guide

Auxiliary Output Explanation Of Settings

Manual Transmission Vehicles

The System Must Be Set Into Reservation Mode To Operate. To Enter Reservation Mode,

the following steps must be followed.

Step 1 - While the vehicle is running, place the transmission in neutral and apply the parking

brake.

Step 2 - Press and release the brake pedal. The park lights will activate and the horn will honk

Step 3 - Turn the ignition key off and the vehicle will continue running.

Step 4 - Exit the vehicle and close the door. The vehicle will then shut off*.

Step 5 - The vehicle can now be safely remote started.

* If the vehicle has a dome light delay, the vehicle may stay running until the dome light turns

off. This is normally no longer than 30 seconds. Reservation Mode will automatically be exited

if the doors of the vehicle are opened. The set-up mode will then have to be repeated .

Reservation Mode Must be set-up each time the vehicle is parked.

To re-enter the vehicle without canceling the Reservation Mode (Forgot something...) the

vehicle must first be remote started. While the vehicle is running the door may be

opened, when done in the vehicle close the door and hold the start button until the

remote starter shuts off. Note: When pressing the start button, the system will flash the

park lights four times slowly If the vehicle has not been placed into Reservation Mode or

if the Reservation Mode has been canceled. (Door Opened, Hood Opened...). Note: If the

system is in the Lock position,* the Unlock button must be pressed before entering the

vehicle while it is running by the remote starter.

* This will be necessary regardless if Keyless Entry was installed or not. The remote

starter is If the system is in the lock position the LED’s on the antenna will flash on and

of once every half second.

Reservation Mode - Manual Transmissions Only

Manual Transmission Remote Starters.

Auxiliary Outputs

Never Install A Automatic Transmission Remote Starter Into A Manual Transmission

Vehicle!!!

If installing on a convertible vehicle,(NOT RECOMMENDED) Install a radar sensor to

protect the proximity of the gear shift lever. The radar should be connected so that if the

field is disturbed the radar sensor module will trigger the door or hood input which will

cancel the Reservation Mode.

The Following Wires Must Be connected In Addition The Basic Starter Connections:

Wire Color Function Connection

- Black/White Park Brake Input Connect to the vehicles park brake wire*

- Green (-)Door Pin Sensing Connect to Negative door pin system.**

- Violet (+)Door Pin Sensing Connect to Positive door pin system.***

* This wire is located at the park brake switch. The wire will switch to (-) when the park brake is

applied.Never connect the Black/White wire straight to a ground!!!

** A Negative door pin wire will be (+) or neutral when the door is closed then switch to (-) when

the door is opened. Always ensure that all the vehicles doors are sensed by this wire.

*** A Positive door pin wire will be (-) or neutral when the door is closed then switch to (+) when

the door is opened. Always ensure that all the vehicles doors are sensed by this wire.

Note: If any Door Pin Switches or the Park Brake Switch is not working correctly... “DO NOT

INSTALL THIS SYSTEM UNTIL THE VEHICLE IS REPAIRED!!!”

In most cases the clutch switch will need to bypassed during Remote Starting. This is a

temporary bypass, the clutch switch should never be disconnected or altered to not work

as it is indented to.(AS A SAFETY SWITCH)

There are several styles of clutch switches and all are bypassed in a different manner.

Ground On Start (Low Current)

This output will supply a 500ma ground output at the same time the starter motor

engages. The output will stay on until the starter motor disengages. This output can be

used for Low Crank (Bulb Test) activation on the GM Passlock system, GM Daytime

Running Lights, Second Starter Relays and Negative starter wire like what is found on

the 2001/2002 Dodge Caravans.

Park Lights (-) (Low Current)

This output will supply a 500ma ground output for the activation of negative park light

systems. This output will work exactly as the positive park light output does.

Second Lock (Low Current)

This output will supply a 500ma ground output if the lock button is pressed twice within

three seconds. This output can be used to trigger such things as Window Roll-up

Modules and power sunroof control.

Dome-Light Supervision (Low Current)*

This output will supply a 500ma ground output for 30 seconds when the unlock button is

pressed. This output can be used to turn on the vehicles Dome Light circuit for added

safety and convenience. The output will turn off when the ignition is turned on and the

brake is pressed.

Latched Output (Low Current)*

When activated this output will latch and supply a 500ma ground output. The latched

output will stay active until the ignition is turned on, the system is armed, disarmed or if

the same button(s) is pressed again.

60 Second Output (Low Current)*

When activated this output will supply a 500ma ground output for a period of 60

seconds. The output will stay active until the ignition is turned on, the system is armed

or disarmed by the remote transmitter.

Momentary Output (Low Current)*

When activated this output will supply a 500ma ground the output will stat on until the

activation button is released. This output can be used to trigger such things as Window

Roll-up Modules and power sunroof control.

Note: Buttons 5 and 6 on the remote transmitter must be programmed on before they

will control any functions. Button 5 must be programmed on first in the Starter settings

menu, setting six, option 2 (Aux. Output). Button number 6 must be programmed in the

Auxiliary Options Menu setting #5

*Low current outputs are designed to activate relays and should never be used

for accessory’s that require more than 500ma.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag

Ultra Start KE-6 Przewodnik Instalacji Strona 12

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Elektronika samochodowa Ultra Start KE-6